Mitsubishi Lossnay LGH-150RVXT-E Handbook page 43

For LGH-250RVXT-E
1 Remove the control cover. → See (3) 1.
2 Check that LED4 on the control circuit board is OFF. → See (2) 2.
3 Unscrew the screws (ten PTT screws 4×8, indicated by ), and remove the control base from the main unit.
4 Unscrew the screws (three PT screws 4×8, indicated by ), and remove the sub control base.
5 Unscrew the screws (two PT screws 4×8 for each, indi-
cated by ) to remove the reactors.
Note: LGH-250RVXT-E Lossnay has ten reactors.
Assembly precaution
Number indications are attached on the lead wires.
When replacing the reactors, install them to the correct
position, and reconnect the lead wires according to the
numbers shown in the picture.
Sub control base
Control base
─ 43 ─
Reactor (Yellow)
11
1
12
2
13
3
4
14
5
15
6
16
7 17
8 18
9 19
10 20
Reactor (Yellow) Reactor