Roughly Aligning The Machine; Figure 5-3 Condensation Water Drain For Horizontal Mounting - Siemens SIMOTICS FD 1MH1 Operating Instructions & Installation Instructions

Allow the condensation water to discharge for horizontal placement
The water drain holes are located in the lower side of the stator enclosure, and sealed with
screw plugs.
Figure 5-3
To drain the condensation water, proceed as follows:
1. Remove the screw plugs to allow the condensation water to drain.
2. Then reinsert the screw plugs.
NOTICE
The degree of protection is reduced
Nominally the degree of protection of the machine is reduced to IP44 when the screw plug is
removed.
5.2.10

Roughly aligning the machine

Requirement
The transmission element such as a coupling half has already been pulled on.
Roughly aligning the machine
● For horizontal positioning, push the motor sideways across the foundation. When doing so,
SIMOTICS FD 1MH1
Operating Instructions 08/2017
Condensation water drain for horizontal mounting
ensure that the axial position is maintained.
5.2 Lift the machine to where it will be installed, and position it
Assembly
71