Install The V Ring - Siemens SIMOTICS FD 1MH1 Operating Instructions & Installation Instructions

Maintenance
9.2 Corrective Maintenance
3. Prepare the bearing seats:
4. Warm up the roller bearing.
5. Push the inner ring of the warmed up roller bearing onto the shaft. Avoid any blows that
6. Make sure that the roller bearing is resting against the shaft shoulder or the second bearing.
7. Fill the bearing to the top with the specified lubricating grease as stamped on the lubricant
8. Warm up the grease slinger and push it onto the shaft.
9. Depending on the particular version, fix the bearing with a locking ring or shaft nut.
10.Support the rotor when installing the bearing housing or bearing end shield.
11.Use a suitable sealant when assembling.
12.Assemble the bearing shield or bearing housing together with the bearing shield.
13.Install the outer bearing cover if one is being used.
14.Install the sealing elements:
9.2.3.5

Install the V ring

Requirement
The roller bearing is already fitted.
150
– Lightly oil the inner ring seat.
– Grease the outer ring seat with a solid lubricant such as Altemp Q NB 50.
– Press the inner bearing cover onto the shaft.
might damage the bearing.
plate.
If present: V ring (Page 150)
Labyrinth sealing ring (special design) (Page 152)
SIMOTICS FD 1MH1
Operating Instructions 08/2017