Sanyo Mini ECO-i 85464359981002 Installation Instructions Manual page 38

(5) Align the installation holes on the panel with the
bolt holes on the unit.
(6) Insert the supplied washer head bolts into the 4
panel installation holes, and tighten until the panel
is securely fastened against the unit. (Fig. 3-54)
(7) Verify that the panel is securely fastened against
the unit.
G At this time, make sure that there is no gap
between the indoor unit and the ceiling panel, or
A
between the ceiling panel and the ceiling surface.
(Fig. 3-55)
G If there is a gap between the ceiling panel and the
ceiling, leave the panel attached and adjust the
installation height of the indoor unit upwards until
the gap with the ceiling is eliminated. (Fig. 3-56)
G If the adjustment is small enough that it will not
affect the levelness of the indoor unit or the drain
piping, then the unit height can be adjusted from
the side panel installation holes, with the ceiling
panel still attached.
Ceiling surface
CAUTION
• If the screws are not fully tightened,
problems such as those shown below
may occur. Be sure to tighten the
screws securely.
Air leakage
Ceiling panel
air leakage
Stains
Condensation and water leakage
Must be no gap.
Indoor unit
Ceiling panel
Fig. 3-55
Indoor unit
Ceiling panel
• If there is a gap between the ceiling
surface and the ceiling panel even
when the screws are fully tightened,
readjust the height of the indoor unit.
(Fig. 3-56)
Adjust so that there is no gap.
38
Washer-head screw
Fig. 3-54
Insert a wrench or other
standard tool into the side
panel installation holes
and make fine adjustments
to the indoor unit nuts.
Fig. 3-56