I How To Start Group Operation - Sanyo RCS-BH80UA.WL Instruction Manual

I How to start group operation

To start group operation
2
1
9
8
Power
1
2
3
4
5
6
3
7
8
9
AUTO
Operation
Stop
3 - 8
Turn the power supply switch on more than 5 hours before starting operation.
Press the SELECT button and select GROUP.
Select the ZONE No. including the group to be operated by pressing ZONE button.
Select the GROUP No. to be operated by pressing GROUP select buttons
Press the ON button.
Set the operation mode by pressing the MODE button.
Set the desired temperature by pressing one of the temperature setting buttons
Set the desired fan speed by pressing the FAN SPEED button.
Set the airflow direction to a specific angle or sweep mode.
By pressing , select your desired setting.
Individual: ¡ Controls with the remote controller are possible.
Central 1: ¡ Individual ON/OFF operation with the remote controller is inhibited.
Central 2: ¡ Individual ON/OFF, MODE, and Temp. setting operations with the remote
controller are inhibited.
Central 3: ¡ Individual MODE and Temp. setting operations with the remote controller are
inhibited.
Central 4: ¡ Individual MODE operation with the remote controller is inhibited.
• Under Central/Individual settings other than listed above, "CENTRAL" is displayed.
Depending on the difference between the temperature setting and the room temperature,
heating and cooling alternate automatically so that a uniform room temperature is maintained.
Confirming the GROUP No. to be selected, press the OFF button.
NOTE
The flap setting can be performed only for units that have no remote
NOTE
controllers.
4
Stop
3
5
6
7
.
.