I Display - Sanyo RCS-BH80UA.WL Instruction Manual

I Display

F
B
G
E
K
D
I
A
A: When the unit is in the heating standby mode, the
B: The currently selected operation mode is displayed.
C: The currently selected FAN SPEED, Airflow Direction and SWEEP
settings are displayed.
D: This indication appears when the filter needs cleaning.
E: This indication appears only when an abnormality occurs within a unit.
F: The currently selected mode (ALL, ZONE or GROUP), ZONE number
and GROUP number are displayed.
GROUP number display (no figure: no number registered)
GROUP state display (
selected group)
Operation state display(
G: The currently selected central control mode (1, 2, 3 or 4) is displayed.
H: Lights when any of the air conditioners under the system control is
operating; turns off when none of the air conditioners under the system
control is operating. Blinks when any conditioner is operating under
abnormal conditions and its protection functionality is working.
I:
When the button is pressed for more than four seconds, the TEST
indicator appears.
J:
This indication appears when the temperature is set.
K: When turning on the power switch of the system controller,
blinks for a few minutes. While blinking, any controls using the system
controller are inhibited. This is because the system controller is verifying
connected groups.
Description
: registered group,
: on,
no sign: off,
: alarm)
H
C
J
indicator appears.
: currently
sign
3 - 7
3