Remote Control Unit - Sanyo RCS-BH80UA.WL Instruction Manual

F: FLAP button
.
G: TIMER SET button
H: Time setting buttons
I: SET button
2
J: CL button
K: SENSOR
L: VENTILATION button
M: TRANSMITTER
N: ADDRESS button
2 - 10
Remote Control Unit (continued)
( ) 1. Use this button to set the airflow direction to a specific angle.
The airflow direction (
NOTE This function is available only for models X and T.
NOTE
( ) 2. Use this button to make the airflow direction sweep up and down
automatically.
Press this button several times until the (
the display.
NOTE This function is available only for models X, T and K.
NOTE
Use this button while the unit is operating to switch between timer
settings:
(OFF Timer)
(OFF Cycle Timer)
(ON Timer)
Use this button to set the timer.
Use this button to clear the timer setting.
A temperature sensor inside the wireless remote controller senses the
room temperature when switched from a temperature sensor inside the
indoor unit.
Use this button when you installed a ventilation fan available in the
market.
Pressing this button turns on and off the fan.
When turning off the air conditioner, the fan will be also turned off.
While the fan is operating,
When you press the buttons on the wireless remote controller, the
mark appears in the display to transmit the setting changes to the
receiver in the air conditioner.
By pressing the ADDRESS button of the remote controller, the display
of the remote controller indicates the current address. If this address
matches with the address of the controller in an indoor unit, the buzzer
will beep. The buzzer will always beep if the indicated address is "ALL".
If the indicated address is "ALL", you can operate any of your indoor
units regardless of their setting of controller addresses. Direct the
remote controller to the remote control receiver of the indoor unit you
want to operate and send a signal. (See p.11, How to set the
ADDRESS.)
) is displayed on the remote control unit.
Operation mode
(COOL) or (DRY)
(HEAT) or (FAN)
(AUTO)
Cooling mode:
Heating mode:
• In the cool mode and dry mode, when the flaps are set in a
downward position, condensation may form and drip around
the vent.
• Do not move the flap with your hands.
:The air conditioner stops after the length of time set.
:The air conditioner after the same set time every time.
:The air conditioner starts after the length of time set.
:Press this button to increase the time.
:Press this button to decrease the time.
Number of airflow direction settings
3
5
3
5
) symbol appears on
will appear in the display.