Display (Wireless Remote Controller); Operation - Sanyo RCS-BH80UA.WL Instruction Manual

How to set the ADDRESS (
Setting addresses of indoor units for remote controller
NOTE • If the set address on the remote controller matches with the controller address in an indoor unit, the
NOTE
buzzer will beep.
Address indication
on the remote
controller
Setting of the
address switch of
the controller in an
indoor unit
Match this address with
the address indicated
on the remote
controller.
SWITCH
E
2
B
2 - 12
)

Operation

1. Press the ADDRESS button for
more than four seconds.
2. By each pressing the ADDRESS
button, the indicated address will
change from "ALL" to "1" through "6"
in turn and lap to "ALL". Adjust the
address switch of an indoor unit you
want to operate to match its address
with the address indicated on the
remote controller.
3. Press the SET button.
If the remote If the remote
controller indicates controller indicates
"ALL": "1":
You can set any
address in the
controller.
• To set the address to 1, 2, or 3, switch this "SWITCH" knob to the left;
NOTE
to set the address to 4, 5, or 6, switch this "SWITCH" knob to the right.
Display
A
(Wireless Remote Controller)
D
C
A: When you press the SENSOR button, the
appears or disappears.
B: The currently selected operation mode is displayed.
C: When setting the timer, the selected timer mode is displayed.
D: The currently selected FAN SPEED, FLAP ANGLE and SWEEP status
are displayed.
E: This indicator flashes when you operate the wireless remote controller.
Indication
The display of the remote
controller indicates
and the current address
appears and blinks.
The indicated address
stops blinking and remains
for five seconds.
If the remote If the remote
controller indicates controller indicates
"2": "6":
Description
(SENSOR) indicator
,