Editing - Simrad AI80 User Manual

To facilitate recognition, the uppermost line on a dialogue box is
composed of a start pattern of three * signs, and a post fixed pattern of
* until the end of the line. A dialogue box prompting for PIN code
appears like the figure below.

Editing

The user can edit a variable by pressing
value of the current variable is stored and the user can start editing the
data. The user selects characters by repeatedly pressing numeric
buttons,
- Static data ----------
MMSI: 000000001
Pos Source: Internal
SurveyedLat: 00°00'▼
or, in cases were there are predefined variables, chooses from a list of
these by using the
- Serial --------------
Sensor 1: 4800
RTCM : 9600!
PI : 38400
The button between the displays indicates that pressing this button
when in the screen to the left, will result in the changes seen in the
screen to the right.
After editing, press
press
length of the display (20 chars), it automatically scrolls. When editing
is completed and
holding the
Man_user_AI80_r2
*** PIN Code ***********
*B
[Cancel]
2 ABC
1 x
or
UP DOWN ARROW
2 ABC
1 x
▼
to confirm changes and exit Edit mode, or
OK
to discard changes. If the input exceeds the horizontal
CANCEL
is pressed, it scrolls back. Values are saved by
OK
button pressed.
OK
User interface
[OK]
when highlighted. The
EDIT
- Static data ----------
MMSI: 000000002
Pos Source: Internal
SurveyedLat: 00°00'▼
buttons.
- SETTINGS -------------
Sensor 1: 4800
RTCM : 4800!
PI : 38400 ▼
11