Step 1 Setting The Hardware; Connecting The Pc Card To The Connecter Cable - Contec COM-1(PM) User Manual

Step 1 Setting the Hardware

This section describes how to set the PC Card and plug it on your PC.
Check that your PC has a TYPE II PC card slot that complies with PCMCIA 2.0/JEIDA 4.1 or later
(including PC Card Standard).

Connecting the PC Card to the Connecter Cable

Connect the PC card end of the cable (CB-1R(PM) or CB-1D(PM)) to the PC card. Make sure you
connect the cable as shown in Figure 2.1 with the top side of the connector (indicated by the
aligned with the top side of the card.
CAUTION
- When inserting the cable, carefully align the cable connector with the socket on the PC card and
push straight in. Applying excessive force to the connector on the PC card may damage the
connector or result in a bad connection.
- Never insert or unplug the connector while the PC power is turned on. However, you may insert or
remove the PC card with the power on.
Connection Cable
Locking Spring
Locking Metal Fitting
PCMCIA Slot Side
Figure 2.1. Connecting the PC Card to the Connecter Cable
COM-1(PM), COM-1D(PM)
Marks
PC Card
2. Setup
mark)
11