Table of Contents
Advertisement
3. External Connection
This chapter describes the interface connectors on the PC Card.
Check the information available here when connecting an external device.
Interface connector
In the case of COM-1(PM)
Use the interface connectors on the CB-1R(PM) cable to connect to external devices.
- Connector used
DELC-J9PAF-20L9 (mfd. by JAE, Male)
- Applicable connectors
17JE-13090-02(D8C) (mfd. by DDK, Female)
CN5-D9F (mfd. by CONTEC, Female) (Five connector set)
Figure 3.1. Interface connector <COM-1(PM)>
Signal Ground
Data Terminal Ready
DTR
Transmit Data
TxD
Receive Data
RxD
Data Carrier Detect DCD
Figure 3.2. Pin Assignments of Interface Connector <COM-1(PM)>
Cable (Option)
RS-232C Straight Cable with D-SUB9P (1.8m)
RS-232C Cross Cable with D-SUB9P (1.8m)
COM-1(PM), COM-1D(PM)
Thumb screw : UNC#4-40
(inch screw)
SG
5
RI
9
4
CTS
8
3
RTS
7
2
DSR
6
1
CN1
5
9
6
1
(CN1)
Ring Indicator
Clear to Send
Request to Send
Data Set Ready
:
:
3. External Connection
RSS-9M/F
RSC-9F
27
Advertisement
Table of Contents
