Step 2 Setting The Hardware; Parts Of The Board And Factory Defaults - Contec DI-64T-PE User Manual

2. Setup

Step 2 Setting the Hardware

This section describes how to set the board and plug it on your PC.
The board has some switches to be preset.
Check the on-board switches before plugging the board into an extension slot.
The board can be set up even with the factory defaults untouched. You can change board settings later.

Parts of the Board and Factory Defaults

Figure 2.1. shows the names of major parts on the board.
Note that the switch setting shown below is the factory default.
- Interface connector
(CN1)
B48
A48
A47
B47
A02
B02
A01
B01
Figure 2.1. Component Locations
16
SW1
BOARD ID
- Board ID setting switch
(SW1)
DIO-3232T-PE, DI-64T-PE, DO-64T-PE
SW1
BOARD ID
8