Control Rods/Grips/Handlebars - J&J Amusements 24v 1750 rpm Service Manual

3-5
CONTROL RODS
Each control rod has a spring located between
the rod and the bottom of the tube.
If the rod doesn't return to the fully raised
position, the spring will need to be replaced.
Unbolt the magnetic trigger to remove the control rod.
Use a magnet to remove the spring.
Spring
The countersink hole in the control rod
faces the slot on the handlebar.
Line up the countersink hole on the control
rod with the slot in the handlebar.
Install the magnetic trigger and make sure to
orient the trigger with the magnet facing down,
so the trigger can function properly.
NOTICE:
Apply anti-seize to the threads on the shoulder bolt.
phone: 1-800-854-3140 | 1-503-304-8899 fax: 1-800-366-7505 | 1-503-304-1899 www.jjamusements.com