Trim Installation/Removal - J&J Amusements 24v 1750 rpm Service Manual

1-19

TRIM INSTALLATION/REMOVAL

The boat trim is mounted with 9 stainless
steel rivets and double-sided tape.
REMOVAL
To remove the old trim, fi rst drill out the rivets
and pull the trim off of the fi berglass.
Make sure to remove any trim adhesive and
thoroughly clean off the surface of the fi berglass
before installing the new boat trim.
INSTALLATION
Heat trim before installing.
Peel off 2"of tape backing.
Line up the trim with the center of the vent plate.
Carefully wrap the trim around the boat top, pulling
the tape backing off in 2 inch sections at a time.
Cut off any excess trim.
phone: 1-800-854-3140 | 1-503-304-8899 fax: 1-800-366-7505 | 1-503-304-1899 www.jjamusements.com