Stanley MSD 1000 Safety, Operation & Maintenance Manual page 89

SPEED VALVE ADJUSTMENT
SPEED VALVE ASSEMBLY TORQUE VALUES:
Proper bolt installation is critical to ensure the safe and effi cient operation of the speed valve. Carefully follow
the steps below to properly install bolts.
NOTICE
Please note that the parts illustrated below (Figure 5-51) and on pages 5-54 through 5-55 are for speed valve
#511461, which is used in MSD 7500 and 9500 shears.
1. Always replace bolts and nuts with the same size and class of fastener. Replacement fasteners can be
ordered from the Stanley LaBounty Parts Department to ensure the correct part is used. Unless otherwise
specifi ed, use class 10.9 metric hex head capscrews, class 10.9 metric fl at head capscrews, and class 12.9
metric socket head capscrews.
2. Make sure bolts, nuts and bolt holes are free of dirt, oil, grease and other contaminants. .
3. The torque values in this manual are for use with non-plated fasteners with clean, dry threads. These val-
ues are suitable for use with or without thread adhesives, such as Loctite products.
SPEED VALVE
ASSEMBLY
P/N 511461 USED IN
MSD 7500 AND 9500
SHEARS
FIGURE 5-51
ITEM PART NUMBER
6 512210
MSD SABER SERIES SHEARS
continued
MSD 7500, 9500 SHEARS
DESCRIPTION
Socket Head Screw
M8X1.25X35
6
QTY TORQUE
4 31 ft lbs/43 Nm
Maintenance Section 5 Page 51