Operating And Commissioning; Safety Instructions; Knowing The Operating Levels - Burkert 8222 ELEMENT Operating Instructions Manual

Type 8222 ELEMENT
Operatingandcommissioning
9 opErATiNg AND coMMissioNiNg
• The settings can only be done on a device with a display module.
• Do not remove the display module while making the settings on the device.
9.1 safety instructions
Warning
risk of injury due to non-conforming adjustment.
Non-conforming adjustment could lead to injuries and damage the device and its surroundings.
▶ The operators in charge of adjustment must have read and understood the contents of the Operating
Instructions.
▶ In particular, observe the safety recommendations and intended use.
▶ The device/installation must only be adjusted by suitably trained staff.
Warning
Danger due to non-conforming commissioning.
Non-conforming commissioning could lead to injuries and damage the device and its surroundings.
▶ Before commissioning, calibrate the conductivity sensor (see chap. 9.12.4).
▶ Before commissioning, make sure that the staff in charge have read and fully understood the contents of the
Operating Instructions.
▶ In particular, observe the safety recommendations and intended use.
▶ The device/installation must only be commissioned by suitably trained staff.
9.2 Knowing the operating levels
The device has 2 operating levels:
process level
This level is used:
• to read the measured values of 2 process values selected in the Parameters menu,
• to read both the lowest and highest values of the chosen process value, that have been measured by the device
since the latest reset (this feature is not active by default),
• to reset both the lowest and highest values of the chosen process value, if the feature has been activated,
• to read the current values emitted on the 4...20 mA outputs.
• to get the state of the device and of the conductivity sensor with the icons.
English
31