Inflate Tires - Slime 40031 Instructions Manual

Pro power tire inflator

Available languages

CAUTION: HOT • DO NOT HOLD IN HAND WHILE OPERATING • PLACE INFLATOR ON A

HARD, CLEAN SURFACE.

1. DO NOT run vehicle while inflator is operating. Engine must be turned OFF.

2. DO NOT use inflator continuously for more than 10 minutes. Allow unit to cool

approximately 25 minutes between uses. Do not leave inflator unattended.

3. ALWAYS use a pressure gauge to check tire pressure. DO NOT overinflate.

4. Keep inflator out of reach of children.

5. For use with 12 volt DC power outlets rated 15 amps or higher. Do not use with older

8 amp cigarette lighter receptacles.

INFLATE TIRES

1. Screw air hose connector onto tire's valve stem.

2. Plug power cord into 12 volt accessory power outlet.

3. Press on switch to turn on inflator. Inflate tire to manufacturer's recommended air

pressure.* When proper pressure is reached, press off switch to turn off inflator. Unplug

power cord and remove air hose connector.

*NOTE: Correct tire pressure can be found in vehicle owner's manual or on driver's side

door jamb.

Table of Contents