Extron electronics HC 404 Setup Manual page 11

Step 9 — Mount the HCT 102 D
Disconnect power at the source from all devices
1.
in the system.
Insert the cabled transmitter into the mud ring
2.
or junction box within the wall or
furniture, aligning the mounting holes
in the transmitter with those in box
or mud ring (see figures 9 and 10,
1 ).
Secure the transmitter to the junction
3.
box or mud ring as follows (
Insert the included screws
a.
through the oval mounting
holes at the top and bottom
of the transmitter and into the
corresponding threaded holes in
the box or mud ring.
Using a Phillips screwdriver,
b.
lightly tighten the screws until
snug.
Attach the wallplate to the
4.
transmitter:
Align the wallplate openings
a.
with the faceplates of the
transmitter, and place the
wallplate against the unit.
Insert screws through the
b.
wallplate mounting holes (
lightly tighten the screws until snug.
Do not over-tighten.
Reconnect power to all devices.
5.
2
):
3.75"
3 ) and
Wall Box
Wall
4.06"
Wall Mouting
Bracket
HCT 102 D
Figure 9. Mounting the HCT 102 D
Transmitter to a Mud Ring
Wall
1 1
HCT 102 D
Figure 10. Mounting the
HCT 102 D Transmitter
to a Junction Box
1 1
IN
D IO
A U
A IN
V G
IN
D IO
A U
IN
M I
H D
2 2
Wallplate
IN
D IO
A U
A IN
V G
IN
D IO
A U
IN
M I
H D
2 2
Wallplate
3 3
3 3
11