Table of Contents
Advertisement
To configure the AV settings using the OSD and front panel buttons:
Connect an HDMI display device to the HDMI/CEC output connector on the HCR 102.
1.
Power on the receiver and the display device, if they are not already powered on.
2.
Press the front panel Menu button on the HCR 102 (see figure 3,
3.
the image at right). The OSD main menu appears on the display
(see the example below, at right).
The OSD menu system consists of the following menus:
Quick Setup
Picture Controls
•
•
•
Output
•
Audio
•
Communication
and one read-only information screen (Device Info).
Navigate through the menus and make adjustments.
4.
Press the up
and down
a.
H
(see
) to navigate to and highlight the desired menu or
submenu.
Press the Enter button (
b.
to access submenu items for the selected submenu (see
Using the OSD menu to configure the AV settings
information about the contents of each submenu).
Press the up
and down
c.
and highlight submenu items.
Press the Enter or right arrow button to adjust a
d.
submenu item.
NOTE:
The OSD times out and closes after one minute if no
buttons are pressed.
Using the OSD menu to configure the AV settings
•
Use the Quick Setup submenu to set input EDID settings, set output resolution, mute audio, activate video test patterns,
enable or disable DHCP, and set the IP address.
Use the Picture Controls submenu to view the image position and size.
•
•
Use the Input submenu to set the input format for digital inputs, set horizontal and vertical start values, set the total pixels
and phase, set HDCP authorization, and set the EDID for the current input.
•
Use the Output submenu to set output resolution, HDMI output format, and HDCP notification.
Use the Audio submenu to mute audio, set the audio input format (see table below) for the selected input, set program audio
•
volume, and set audio output format (stereo, mono).
Audio Input Format
None
Analog
LPCM-2Ch
Multi-Ch
LPCM-2Ch auto
Multi-Ch auto
•
Use the Advanced submenu to select a test pattern, set the screen saver, set the aspect ratio, configure auto switching, and
reset the device to factory defaults.
•
Use the Communication submenu to view the device MAC address, DHCP status, the current IP address and subnet mask,
and gateway.
NOTE:
Press and hold the Enter button for 10 seconds to edit settings in the Communication submenu.
•
Use the Device Info screen to view the device name, firmware build, temperature, input and output information, and
detected display. This screen is read-only.
See the HC 400 Series User Guide for details about the menus and available settings, and for a list of output scaler rates.
Input
•
•
Advanced
arrow navigation buttons
G
) or right arrow button
arrow buttons to navigate to
Details
Mutes all audio for selected input. Sets "No Audio" EDID.
Sets the selected input to analog (default for input 1). Sets "No Audio" EDID.
Sets the selected input to LPCM-2Ch digital audio (default for input 2). Sets 2Ch audio EDID.
Sets the selected input to Multi-Ch digital audio. Sets Multi-Ch audio EDID.
Sets the selected input to prioritize digital audio (default for inputs 3-4). Analog audio is passed when
digital audio is not present. Sets 2Ch audio EDID.
Sets the selected input to prioritize digital audio. Analog audio is passed when digital audio is not
present. Sets Multi-Ch audio EDID.
F
on page 3, or
Quick Setup
Picture Controls
Picture Controls
Input
Input
Output
Output
Audio
Audio
for
Advanced
Advanced
Communications
Communications
Device Info
Device Info
Menu button
MENU
HOLD
FOR 720p/1080p
ENTER
HCR 102
Enter button
Navigation buttons
9
Advertisement
Table of Contents
