Table of Contents
Advertisement
HC 400 Series • Setup Guide (Continued)
Step 7 — Configure the Control Settings
To use the COM, IR, or digital I/O ports on the receiver, you must configure them. Also, CEC control of the output device can be
customized during configuration with Global Configurator.
The basic steps are outlined below in the recommended order.
See the Toolbelt Help File or Global Configurator Help File, and GUI Designer Help File as needed for step-by-step
NOTE:
instructions and detailed information. The help file for GC includes an introduction to the software and how to start a
project and configuration.
Using GC, create a new GC Pro or GC Plus project and configure the receiver and other IP Link Pro devices. The
1.
configuration tells the receiver:
•
how its control ports function
•
how to control other products
•
which touchpanels to interact with
Configure the control ports on the receiver.
a.
Select device drivers and link them to each serial, IR, or Ethernet port.
•
Select settings (serial protocol or digital I/O settings) as needed.
•
Configure CEC controls, if desired
•
Set up monitors, schedules, macros, timers, and local variables.
b.
Add any optional touchpanels and set them up:
c.
Create the GUI configuration for the touchpanels and add it to the project.
•
Program functions, monitors, or schedules to the touchpanels and their buttons.
•
Save and build the project.
2.
Upload the system configuration to the HCR 102 receiver.
3.
Step 8 — Test and Troubleshoot the System
Test the system. See the HC 400 Series User Guide for an outline of the system testing procedure.
1.
Make adjustments to wiring or configuration as needed.
2.
10
•
what to monitor
•
when to do things
•
whom to notify, how, and under what circumstances
Advertisement
Table of Contents
