General Auxiliary Block Specifications - ABB Symphony Harmony Series Instruction

Table 1-8. General I/O Block Specifications
Property
Field power (IFP/LFP)
LFP terminals
Fusing
Common mode isolation
Tested
Differential input voltage without
damage
Common mode voltage
Input/output protection
Dimensions
Overvoltage (installation) category ANSI/ISA-S82.01-1994 and IEC 1010-1
NOTES:
1. All specification values are maximums unless stated otherwise.
2. Applies only to blocks with isolated input and output channels. Refer to
3. Applies only to blocks with nonisolated input and output channels. Refer to
channels.
WBPEEUI240751C0
(continued)
24.0 VDC nominal
48.0 VDC nominal
125.0 VDC nominal
120.0 VAC nominal
240.0 VAC nominal
3.0 A
Refer to the individual block specifications in
2
300 VDC/V
1,400 V
RMS
±15 VDC/V
3
±5 VDC/V
Continuous short to ground - protected with current limiting
Type
I/O module
Nonredundant base
Redundant base
NOTE: Refer to
I for circuits above 150 V
II for circuits below 150 V
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
Table 1-9. General Auxiliary Block Specifications
Property
Auxiliary blocks
(Refer to indicated table for
individual block specifications)
Characteristic/Value
at 60 Hz
RMS
at 60 Hz for 2 sec
continuous
RMS
continuous
RMS
Height
mm in.
266 10.5
267 10.5
267 10.5
Appendix A for hardware drawings.
Section 2 to determine if a block has isolated channels.
Section 2 to determine if a block has isolated
Characteristic/Value
Block
CIO-110 Table
RLY-100 Table
RLY-200 Table
Specifications
1
Section 2
Width Depth
mm in. mm in.
76 3.0 162 6.4
138 5.4 169 6.7
217 8.5 169 6.7
Refer To
2-8
2-12
2-13
1 - 17