Pairing And Calibrating The 4Iiii Crank - Schwinn AC Power Service Manual

Pairing and Calibrating the 4iiii Crank

22. Press and hold "STAGE" and "AVG/MAX" for 3-5 seconds to
access the service menu.
23. Use "AVG/MAX" to scroll until "SENSOR TYPE" is displayed
then push the backlight button to access the sensor menu.
Ensure that "4iiii" is displayed as the sensor type.
24. If the sensor type is set to "Echelon 2" press the backlight
button to select the sensor type, use the "AVG/MAX" button
to select "4iiii" then press the backlight button again.
25. Once "4iii" is selected the console will enter the pairing pro-
cess, check the label on the power sensor for a 5-digit ANT+
ID code. Enter this code on the "ENTER ANT ID" screen using
"AVG/MAX" to scroll and the backlight to enter the ANT+ ID.
26. Once the ANT+ ID has been entered, pedal the bike, then
select "PAIRING SPIN CRANK" by pushing the back-light
button. If pairing does not pass, check to ensure the ANT+
ID is correct and try the pairing process again. It may take
2-3 attempts to pair successfully.
27. After successfully pairing the 4iiii crank, the power sensor
must be calibrated BEFORE riding the bike. Press and hold
STAGE and AVG/MAX for 3-5 seconds to access the service
menu then use AVG/MAX to scroll until "CALIBRATE" is dis-
played then select it using the back-light button.
28. "ZERO RESET" will be displayed, press the back-light button
to select it. Once "SPINCRANK" is displayed, spin the crank
and press the back-light button to proceed. Ensure that the
left crank arm is in the 6 o'clock position then follow the on-
screen directions to finish calibrating the sensor.
Page 22