Pedal Replacement (Morse Taper)
24.
Use an 8mm allen key to remove the pedal bolt.
NOTE: The crank arm and pedal are shown detached from
the bike for clarity only, it is not necessary to remove the
crank arm.
Thread a crank puller tool with the smaller 11mm tip into
25.
the crank arm, then use the tool to push the pedal out of
the crank arm.
26.
Push the new pedal into the crank arm, then use a torque
wrench coupled with an 8mm allen socket to reinstall the
pedal bolt and torque to the value below:
35-40 ft-lb / 47-54 Nm
11mm
Page 15