Reading Magnetic Stripe Cards; Cleaning The Product Case; Cleaning The Print Head - Epson TM-S9000MJ User Manual

Reading Magnetic Stripe Cards

If your product is equipped with a MSR unit, you can read the magnetic stripe on the card.
Note:
Use a magnetic stripe card which meets the specifications. (See "Specifications" on page 23.)
To read the magnetic stripe card, check the insertion direction with the arrow on the card, and
swipe it through the slit downward or upward with the magnetic stripe on the card facing
inside and down.
The buzzer beeps once when reading succeeds and beeps three times when it fails.
Cleaning

Cleaning the Product Case

Be sure to turn off the product, and wipe the dirt off the product case with a dry cloth or a
damp cloth.
CAUTION:
Never clean the product with alcohol, benzine, thinner, or other such solvents. Doing so may damage
or break the parts made of plastic and rubber.

Cleaning the Print Head

When printing becomes faint or uneven although the Ink LED is not on or flashing, the print
head may need to be cleaned.
In this case, press the cleaning button on the control panel for 3 seconds or more to start the
print head cleaning. During the cleaning,
When (Power) LED comes on after flashing, the print head cleaning is completed.
CAUTION:
Never take the following actions during
• Tilting the product
• Opening the covers
• Turning off the power
Doing so will cause a significant amount of ink to be consumed.
Note:
The cleaning process uses some ink. Do not run cleaning when it is unnecessary.
(Power) LED flashes.
(Power) LED flashes.
16