Scanning Id Cards - Epson TM-S9000MJ User Manual

Scanning ID Cards

Follow the steps below to scan both side of an ID card.
Note:
Use an ID card which meets the specifications. (See "Specifications" on page 23.)
Make sure that the ID card is flat and does not have excessive bending, cracks, folds, or
embossing.
Do not touch the external terminal when using an IC card.
1. Make sure the ID Card LED is flashing.
2. Put the ID card in the insertion slot on the right side of the pocket with its photo side
facing the pocket, and slide it along the bottom of the slot.
3. When the card starts feeding, release it immediately.
CAUTION:
When the ID card is feeding, a part of it comes out of the card carrier slit at the back of the
product. Be sure not to block this slit.
Do not touch the ID card when it is being ejected. Doing so may cause distortion and other
problems with the scanned data.
Do not open the covers while processing is in progress.
4. When the ID card is ejected and the ID Card LED flashes, remove the ID card from the
slot.
15