Pressure Relief Procedure - WAGNER TwinControl 5-60 ABS Translation Of The Original Operating Manual

EDITION 04/2010
OPERATING MANUAL
6.5

PRESSURE RELIEF PROCEDURE

The pressure must always be relieved
- when the spraying tasks are fi nished
- before servicing the system
- before carrying out cleaning tasks on the system
- before moving the system to another location
- if something needs to be checked on the system
- if the nozzle is removed from the gun.
Please read the general safety instructions in chapter 2.
High-pressure spray jet!
Danger to life from injecting paint or solvent
SIHI_0059_GB
Procedure:
1. Secure the gun.
2. Press „Stop" on the
TwinControl control unit.
3. Close air valves on
the pumps for A-, B-
component and solvent.
PART NO. DOC393831
Never reach into the spray jet.
Never point the spray gun at peole.
Consult a doctor immediately in the event of skin injuries caused
by paint or solvent. Inform the doctor about the paint or solvent
used.
Never seal defective high-pressure parts, instead relieve the
pressure from them and replace.
Wear the appropriate protective clothing, gloves, eyewear, and
respirator.
A B
B
A
B
A
BP
WARNING
SET
TwinControl
B_02744
AP
AL4
BL7
TwinControl
LP
LL10
B_02631
.
48