Notes About Usage - Siemens SIMATIC TP900 Comfort INOX PCT Compact Operating Instructions

Safety instructions and additional information

2.3 Notes about usage

2.3 Notes about usage
NOTICE
The HMI device is approved for indoor use only.
The HMI device may be damaged if it is operated outdoors.
Operate the HMI device indoors only.
Note
Operate the device only in a normal atmospheric environment
The technical characteristics of the device described in the operating instructions are
guaranteed if you operate the device in normal ambient air conditions with usual air
composition.
Note
The device is intended for operation in an SELV circuit according to IEC/EN 61010-2-201 in
a dry environment, i.e. dry environment at the rear of the device.
You can find additional information in the section "Operating Conditions (Page 39)".
Industrial applications
The HMI device is designed for industrial applications. It conforms to the following standards:
● Requirements for emissions EN 61000-6-4: 2007
● Requirements for interference immunity EN 61000-6-2: 2005
Use in mixed-use zone
Under certain circumstances, you can use the HMI device in a mixed-use zone. A mixed-use
zone is used for housing and commercial operations that do not have a significant impact on
residents.
When you use the HMI device in a mixed-use zone, you must ensure that the limits of the
generic standard EN 61000-6-3 regarding emission of radio frequency interference are
observed. Suitable measures for achieving these limits for use in a mixed-use zone include:
● Installation of the HMI device in grounded control cabinets
● Use of filters in electrical supply lines
Individual acceptance is required.
14
Compact Operating Instructions, 05/2018, A5E38804191-AA
Comfort Panels INOX PCT