Operating Conditions - Siemens SIMATIC TP900 Comfort INOX PCT Compact Operating Instructions

5.5.3

Operating Conditions

The following information applies to a device installed according to the specifications in these
operating instructions.
The HMI device is designed for weatherproof and stationary operation according to
IEC 60721.
The device meets the requirements according to IEC 60721-3-3 Class 3K3 with the following
amendments and limitations:
Type of condition
Temperature,
Mounting in horizontal format
Temperature,
Mounting in vertical format
High-pressure cleaner
Atmospheric pressure
ation elevation
Relative humidity
Pollutant concentration
TP1900 Comfort and TP2200 Comfort: 0 ... 45 °C
1
No pressure difference is allowed inside and outside the enclosure / control cabinet
2
Read the Notes on use (Page 14).
Also observe the climate diagram in the following section and the specifications for the
extended inclination and ambient temperature range; see section "Permitted mounting
positions (Page 19)".
Note
The system components connected to the HMI device, the power supply for example, must
also be suited to the respective operating conditions.
Comfort Panels INOX PCT
Compact Operating Instructions, 05/2018, A5E38804191-AA
Mounting position
Vertical
Inclined, maximum inclination 35° 0 ... 40 °C
Vertical
Inclined, maximum inclination 35° 0 ... 35 °C
temporarily 80 °C: clean 3 min. maximum with 80 °C hot water, then
let it cool down
, oper- 1140 ... 795 hPa, corresponds to an elevation of -1000 to 2000 m
2
From 10 ... 90%, no condensation on the rear panel of the device
SO2: < 0.5 ppm; relative humidity < 60%,
no condensation at the rear of the device
H S: < 0.1 ppm; relative humidity < 60%,
2
no condensation at the rear of the device
Technical specifications
5.5 Climatic ambient conditions
Permitted range
0 ... 50 °C
1
0 ... 40 °C
39