Table of Contents
Advertisement
Section 1: Assembly & Set-Up
6. Refer to "Single Tail Wheel Height Adjustment" on
page 19 for adjusting instructions.
7.
Tighten all locknuts to correct torque.
Dual Tailwheel Assembly
NOTE: Do not tighten hardware until assembly
is complete. See "Torque Values Chart" on page
35 for correct torques.
Refer to Figure 1-11:
1.
Attach tailwheel bracket (#2) to left side of cutter deck
with four 1/2" -13 x 1 1/2" GR5 hex head
bolts (#6), 1/2" flat washers (#11), and 1/2" flange
lock nuts (#9).
IMPORTANT: The tailwheel arms must be located in
the rear mounting holes of the deck channel when
rear chain guards are included and front mounting
holes when rear chain guards are not included.
11/12/18
Table of Contents
2. Attach tailwheel arm (#1) to deck bracket (#2) with
5/8"-11 x 3 1/4" GR5 hex head bolt (#8), 5/8" flat
washer (#12), and 5/8" locknut (#9).
3. Assemble tailwheel adjusting brackets (#3 & #4) to
left side of deck using four 1/2"-13 x 1 1/2" GR5
carriage bolts (#7) and 1/2" flange lock nuts (#10).
4. Install shim washer (#13) onto yoke spindle (#15)
and insert spindle into tailwheel arm (#1). Slide 2nd
shim washer (#13) onto yoke spindle and secure with
roll pin (#14).
5. Install two 1/2" -13 x 3 1/2" GR5 hex head bolts (#5)
and hex flange lock nuts (#10) in adjusting brackets
(#3 & #4) as shown.
6. Tighten all nuts to correct torque.
7.
Repeat steps 1 through 6 for right side of cutter.
8. Refer to "Dual Tail Wheel Height Adjustment" on
page 19 for adjusting instructions.
Dual Tailwheel Assembly
Figure 1-11
RCR1884 Model Rotary Cutter 312-880M
24665
15
Advertisement
Table of Contents
