D-Link DWM-311 User Manual page 26

4g lte m2m modem
Hide thumbs Also See for DWM-311:
Table of Contents

Advertisement

Section 3 - Configuration
By default, the DWM-311 operates in bridge mode. Any attached devices are assigned
an IP address directly by the ISP. However, for compatibility purposes, some devices
may require an IP address assigned from a local DHCP server. Enabling router mode
ensures that all IPs on the subnet will be assigned by the DWM-311's internal DHCP
server, and all traffic relayed to the ISP via NAT (Network Address Translation).
Note: NAT is considered a type of firewall*, and may interfere with incoming direct
connections over the Internet.
Turn on router
Check this box to enable the DWM-311's internal DHCP server and
mode
NAT. This setting is disabled by default. Enable this setting only if
your clients do not support bridge mode.
Click Apply to save changes or Reset to revert changes.
*This device is not designed to replace a conventional router, and is not intended
for use as a network security device. Filtering and advanced firewall features are
not supported.
D-Link DWM-311 User Manual
Router Mode
Admin
Config (Cont)
23

Advertisement

Table of Contents
loading

Table of Contents