Before You Begin; Installation; Installing Freestanding Dispensers - Follett Symphony Plus 25 series Operation And Service Manual

Ice and water dispensers

Hide thumbs Also See for Symphony Plus 25 series:

Table of Contents

Before you begin

§ All dispensers must be installed level in both directions to ensure proper operation.

§ SensorSAFE™ dispensers are shipped with a plastic, protective film on sensor lenses. For proper operation,

plastic film must be removed after installation.

1. Position dispenser in desired location and adjust legs to level in both directions.

2. Connect water supply to 3/8" FPT fitting on back of dispenser (Fig. 1).

3. Connect separate drain lines to 3/4" MPT dispenser drain fitting, and 3/4" MPT ice machine drain fitting

on back of dispenser.

4. Run drain lines to wall or floor drain. If ice machine drain fitting is below an intended wall drain, a

condensate pump must be used.

5. If ice machine is a water-cooled unit, connect water-cooled condenser supply line to 3/8" FPT condenser

inlet fitting on back of dispenser.

Note: Do not run condenser supply water through ice machine water filter system.

6. Connect condenser drain line to 3/8" FPT condenser outlet fitting on back of dispenser.

Important: Do not connect condenser drain line to any other drain lines.

7. Plug dispenser into 15A rated NEMA 5-15 wall socket.

8. Remove front cover of base section by removing two screws at bottom corners of cover. Allow cover to

drop approximately 3/8" (5 mm) and pull forward.

9. Turn on water supply and check for leaks.

25FB425A/W, 50FB425A/W

Table of Contents

Symphony plus 50 series