Inserting The Bobbin - AEG 30Z Instruction Manual

Instruction manual for Model AEG 30Z /AEG 35Z

Inserting the bobbin

Turn the power switch to off ("O") before
inserting or removing the bobbin.
When inserting or removing the bobbin,
the needle must be fully raised.
Remove the sewing table, then open the
hinged cover.
Pull the bobbin case by the hinged latch.
1
1
Remove the bobbin from the bobbin case.
Hold the bobbin case with one hand. Insert
the bobbin so that the thread runs in a
clockwise direction (arrow).
Pull the thread through the slit and under
the finger.
Leave a 6 inch tail of thread.
Make sure the bobbin case finger fits
into the notch at the top of the race as
illustrated.
13
Attention:
Hinged latch