Removing The Power Supply Wiring Terminal Block And The Upper & Lower Blower Motors - Whirlpool GBD307PD Manual

REMOVING THE POWER SUPPLY WIRING TERMINAL
BLOCK AND THE UPPER & LOWER BLOWER MOTORS
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all panels before operating.
Failure to do so could result in death or
electrical shock.
CAUTION: When you work on the double
oven, be careful when handling the sheet metal
parts. Sharp edges may be present, and you
can cut yourself if you are not careful.
1. Disconnect the electrical power to the
double oven.
2. Remove the side trim from the oven (see
page 4-2, steps 1 through 4 for the proce-
dure).
NOTE: Before you move the double oven from
its mounting location, remove both oven doors
to make it easier to move (see page 2-3 for the
procedure).
3. Remove the four double oven cabinet
mounting screws (2 on each side), and
pull the oven out of its mounting location
so that you can access the back.
Cabinet Mounting Screw
(2 Screws On Each Side)
4. Remove the screw from the conduit clamp
and remove the clamp.
5. Remove the 6 screws from the top rear
oven cabinet cover.
Conduit
Clamp
6. To remove the power supply wiring
terminal block:
a) Remove the hex nuts from the wire
terminal studs and remove the wires
from the studs.
b) Remove the two mounting screws from
the terminal block and remove it from
the top of the oven.
Wiring Terminal Block
Mounting
Screws
4-4
Top Rear Cover
(6 Screws)
Power Supply
Wires