Removing The Convection Fan Motor Assembly - Whirlpool GBD307PD Manual

REMOVING THE CONVECTION FAN MOTOR ASSEMBLY

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all panels before operating.
Failure to do so could result in death or
electrical shock.
CAUTION: When you work on the double
oven, be careful when handling the sheet metal
parts. Sharp edges may be present, and you
can cut yourself if you are not careful.
1. Disconnect the electrical power to the
double oven.
2. To make servicing easier, remove the
upper oven door from the unit (see page
2-3 for the procedure).
3. Remove the racks from inside the oven.
Convection Fan Motor
4. Remove the three screws from the con-
vection fan motor cover and remove the
cover from the rear of the oven liner. Note
the location of the notch in the cover. Be
sure to position the cover with the notch as
shown when you reinstall it.
5. Use a 10 mm (7/16˝) socket and remove
the hex nut from the convection fan. NOTE:
The nut has a left-rotation thread for re-
moval.
6. Remove the three front convection fan
motor screws from the rear of the oven
liner.
4-12
Screw 1 of 3
Convection
Fan Motor
Cover
Notch
Convection
Fan
10 mm
(7/16˝)
Hex Nut
Convection
Fan Motor
Front Screw
(1 of 3)