Removing The Thermal Fuse, The Oven Control/Display Boards, And The Touch Panel Assembly - Whirlpool GBD307PD Manual

REMOVING THE THERMAL FUSE, THE OVEN CONTROL/
DISPLAY BOARDS, AND THE TOUCH PANEL ASSEMBLY
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all panels before operating.
Failure to do so could result in death or
electrical shock.
CAUTION: When you work on the double
oven, be careful when handling the sheet metal
parts. Sharp edges may be present, and you
can cut yourself if you are not careful.
1. Disconnect the electrical power to the
double oven.
2. Open the lower oven door.
3. Remove the bottom screw from each of
the two side trim pieces (see below).
4. To remove the side trim, pull the bottom
out approximately 2˝, and slide the top
down to free it from the control panel.
Side Trim Screw
(1 On Each Side)
Pull Side Trim
Down & Away
From Control
Panel
Pull Out Bottom
Of Side Trim
4-2
5. Remove the screws from the oven control
panel.
Control
Panel
Screw
6. To remove the oven control panel, pull it
out at the bottom, and lift and unhook it
from the oven cabinet support at the top.
Oven
Control
Panel
Lift Off
Top
Support
7. Disconnect the wire connectors from the
control board and set the panel face down
on a padded surface to protect the finish.
Thermal Fuse
8. To remove the thermal fuse, disconnect
it from the main harness connector.
Pull
Out
6 Wire Connectors
Harness
Connector