C H A P T E R
3
Starting and stopping Historical Server on UNIX
platforms
Starting Historical Server on UNIX
User's Guide
Starting and Stopping Historical
Server
Topics
Starting and stopping Historical Server on UNIX platforms
Starting and stopping Historical Server on Windows NT
This section describes how to start and stop Historical Server running on
UNIX platforms.
On UNIX, you can start a configured Historical Server in two ways:
•
Execute the
histserver
use this method, you must type all appropriate parameters each time.
•
Execute a script file that contains the
appropriate parameters. If you followed the configuration
instructions in Chapter 2, "Configuring Historical Server," you
would start Historical Server using:
install_dir/install/RUN_histServerName
where install_dir is the Sybase root directory and histServerName is
the name of the Historical Server you want to start.
Regardless of which method you use:
•
Verify that the Adaptive Server to be monitored and its corresponding
Monitor Server are running.
command from a UNIX shell prompt. If you
histserver
Page
33
36
command and all
33