Table of Contents
Advertisement
OPERATING PROCEDURES
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
BEFORE INITIAL USE
B
Read and follow the safety label on the instrument panel. Be sure to understand safe operation of the vehicle and its
equipment.
Hydrogen gas is generated as a natural part of the lead acid battery charging process. A 4% con-
centration of hydrogen gas is explosive and could cause severe injury or death. Charging must
take place in an area that is adequately ventilated (minimum of 5 air exchanges per hour).
To reduce the chance of battery explosion that could result in severe injury or death, never smoke
around or charge batteries in an area that has open flame or electrical equipment that could cause
Before a new vehicle is put into operation, the items shown in the INITIAL
SERVICE CHART must be performed.
Vehicle battery must be fully charged before initial use.
Check for correct tire inflation. See GENERAL SPECIFICATIONS.
Check for oil or fuel leaks that could have developed in shipment from the
factory.
Determine and record braking distance required to stop vehicle for future
brake performance tests.
Remove the clear plastic (used to provide protection during shipping) from
the seat.
OPERATING THE VEHICLE
Improper use of the vehicle or the lack of proper maintenance may result in damage or decreased perfor-
Read and understand the following warnings before attempting to operate the vehicle.
To reduce the possibility of severe injury or death resulting from loss of vehicle control, the follow-
When driving vehicle, consider the terrain, traffic conditions and the environmental factors
which effect the terrain and the ability to control the vehicle.
Refresher unit is intended for use on improved surfaces.
Use extra care and reduced speed when driving on poor surfaces, such as loose dirt, wet
grass, gravel, etc.
Stay in designated areas and avoid extremely rough terrain.
en-20
an electrical arc.
mance.
ing warnings must be observed:
Owner's Guide
ITEM
SERVICE OPERATION
Battery
Charge battery
Seats
Remove protective plastic covering
Brakes
Check operation and adjust if necessary
Check hydraulic brake fluid level if equipped
Establish acceptable stopping distance
Tires
Check air pressure (see SPECIFICATIONS)
Fuel
Fill tank with correct fuel
Engine
Check oil level
INITIAL SERVICE CHART
Advertisement
Table of Contents
