Transporting Vehicle; Neutral Lock; Hauling - Cushman REFRESHER FS2 Owner's Manual

Hide thumbs Also See for REFRESHER FS2:
Table of Contents

Advertisement

MAINTENANCE
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.

TRANSPORTING VEHICLE

It is recommended that the vehicle be moved by placing the entire vehicle on a trailer, flatbed truck or other suitable
transport.

Neutral Lock

To prevent the driven clutch from turning the rear wheels during service operations, a neutral lock is located on the direc-
tion selector.
To operate:
Turn key switch to 'OFF' and lift front seat bottom. Pull out (1) and
rotate (2) the neutral lock pin handle so that the pointed portion of
the handle is to the side of the direction selector cam. Move direc-
tion selector towards the area between 'F' and 'R'. During that
motion the pin will snap into the hole in the direction selector
mounting bracket preventing any movement. When in this position,
the direction selector remains locked in the neutral position. To
unlock the direction selector, pull the neutral lock pin handle out
and rotate until the pointed portion of the handle fits into the hole in
the direction selector cam.

Hauling

To reduce the possibility of severe injury or death while transporting the vehicle:
Secure the vehicle and contents.
Never ride on a vehicle being transported.
Always remove the windshield before transporting.
Ensure drawers, doors, and cabinets are locked and countertops are locked in place.
Ensure unit is empty to avoid weight shifting.
Remove canopy if transporting at highway speeds.
If the vehicle is to be transported at highway speeds, the canopy must be removed and the seat bottom secured. When
transporting vehicle below highway speeds, check for tightness of hardware and cracks in canopy at mounting points.
Always remove windshield when transporting. Always check that the vehicle and contents are adequately secured before
transporting. The rated capacity of the trailer or truck must exceed the weight of the vehicle (see GENERAL SPECIFICA-
TIONS for vehicle weight) and load plus 1000 lbs. (454 kg). Secure the vehicle using ratchet tie downs.
en-44
This vehicle is not designed to be towed.
Owner's Guide
Hole in Direction
Selector Cam
Unlocked

Advertisement

Table of Contents
loading

Table of Contents