Table of Contents
Advertisement
MAINTENANCE
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
MAINTENANCE
VEHICLE CLEANING AND CARE
To reduce the possibility of severe injury or vehicle damage, read and understand all instructions
supplied by manufacturer of pressure washer.
When pressure washing exterior of vehicle, do not use pressure in excess of 700 psi. To reduce the possibil-
ity of cosmetic damage, do not use any abrasive or reactive solvents to clean plastic parts.
It is important that proper techniques and cleaning materials to be used. Using excessive water pressure may cause
severe injury to operator or bystander, damage to seals, plastics, seat material, body finish or electrical system. Do not
use pressure in excess of 700 psi to wash exterior of vehicle.
Clean windshield with lots of water and a clean cloth. Minor scratches may be removed using a commercial plastic polish
®
or Plexus
plastic cleaner available from the service parts department.
Normal cleaning of vinyl seats and plastic or rubber trim requires the use of a mild soap solution applied with a sponge or
soft brush and wipe with a damp cloth.
Removal of oil, tar, asphalt, shoe polish, etc. will require the use of a commercially available vinyl/rubber cleaner.
The painted surfaces of the vehicle provide attractive appearance and durable protection. Frequent washing with luke-
warm or cold water and mild detergent is required to preserve the painted surfaces.
Occasional cleaning and waxing with non-abrasive products designed for 'clear coat' automotive finishes will enhance
the appearance and durability of the painted surfaces.
Corrosive materials used as fertilizers or for dust control can collect on the underbody of the vehicle. These materials will
cause corrosion of underbody parts unless flushed occasionally with plain water. Thoroughly clean any areas where mud
or other debris can collect. Sediment packed in closed areas should be loosened to ease it's removal, taking care not to
chip or otherwise damage paint.
If the engine does not start or runs improperly after washing, remove the spark plug wires (by pulling the spark plug
boots, never the wires). Dry all connections with forced air. Reinstall the wires.
Refresher Unit Cleaning
To obtain optimum use from the FS2 Refresher, regular cleaning is required. Remove all merchandise and product prior
to cleaning. Countertops, module units, side drawer, end cap, and waste compartments should all be cleaned with com-
mercial safe cleaners. Generally, a standard all purpose antibacterial cleaner will work for most of the surfaces. Ensure
all surfaces are dried and free of cleaner residue. Drawers and drawer drains must be cleaned and dried after each use.
en-39
Owner's Guide
Advertisement
Table of Contents
