Table of Contents
Advertisement
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
Serial Number Location
The Refresher unit serial number is located on the inside of the right, rear door of the end cap.
Emissions Labels and Engine Access
A pull up plate is located beneath the lower side drawer to allow access to
the engine compartment. Remove the side drawer from its position by slid-
ing it out and set aside. Removing the drawer will expose the pull up plate.
When reinstalling drawer, align both left and right drawer hinges to slides in
the chassis. DO NOT OVER FORCE THIS INSTALLATION. Extreme cau-
tion should be used during this installation process to avoid damage to the
slides.
The emission labels are visible once the engine compartment is accessed.
REFRESHMENT UNIT OPERATION
Lockdown Mechanism
1.
Countertop: The passenger side countertop is removable for module replacement. To remove, lift countertop up
and remove from hinge support. Removing the countertop allows the modules to slide out after releasing the module
clamps (see next section for module clamp operation).
2.
Module Clamps: The Refresher unit modules are secured by module clamps that place a downward force on the
modules. Release and raise the clamp by turning the large nut counterclockwise. Raise the clamp high enough that
a module can be pulled up and out of placement. The clamp must be released on BOTH sides of module.
Turn nut counterclockwise to release
clamp force on
both sides of modules.
OPERATING PROCEDURES
Lift up passenger
side countertop
and remove.
Owner's Guide
Pull up door for
engine access
Drawer slides in and out
of compartment
Countertop off
Module clamp lifts up
B
en-25
Advertisement
Table of Contents
