Before Initial Use; On Board Charger; Identification; Controls, Meters And Switches - Cushman 29175-G01 Owner's Manual And Service Manual

ELECTRIC THREE WHEEL SERVICE VEHICLE
Read all of manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings

BEFORE INITIAL USE

Read, understand and follow safety label on the instru-
ment panel. The vehicle has been designed to operate in
a warehouse or factory environment with semi-smooth
floors, road and ramps.
Be sure you understand the vehicle, its equipment and
how to use it safely. Although the vehicle has been
designed to provide safe and reliable operation, main-
taining good performance depends to a large extent on
the operator.
Vehicle batteries must be fully charged before initial use.
!
ing process. A 4% concentration of hydrogen gas is
explosive and could cause severe injury or death.
Charging must take place in an area that is adequate-
ly ventilated (minimum of 5 air exchanges per hour).
To reduce the chance of battery explosion that could
result in severe injury or death, never smoke around
or charge batteries in an area that has open flame or
electrical equipment that could cause an electrical
arc.
Hydrogen gas is generated in the charging cycle of bat-
teries and is explosive in concentrations as low as 4%.
Because hydrogen gas is lighter than air, it will collect in
the ceiling of buildings necessitating proper ventilation.
Five air exchanges per hour is considered the minimum
requirement.
Never charge a vehicle in an area that is subject to flame
or spark. Pay particular attention to natural gas or pro-
pane gas water heaters and furnaces.
Before a new vehicle is put into operation, it is recom-
mended that the items listed in the INITIAL SERVICE
CHART be performed (Ref Fig. 1 on page 2).
ITEM SERVICE OPERATION
Batteries Charge batteries
Seats Remove protective plastic covering
Check operation and adjust if necessary
Brakes
Tires Check air pressure (see SPECIFICATIONS)
Fig. 1 Initial Service Chart
Page 2
Hydrogen gas is generat-
!
ed as a natural part of the
lead acid battery charg-
Owner's Manual and Service Guide

On Board Charger

The on board charger is wired directly to the batteries,
only requiring it be plugged into a dedicated 15 amp AC
outlet to be operational. When charge cycle is complete,
replace cord in appropriate area under cargo deck.

IDENTIFICATION

The product model number, model year and serial num-
ber must appear on all correspondence concerning this
unit. These identification numbers appear on the decal
attached to the left side of the kick panel.(Ref Fig. 2 on
page 2).
Fig. 2 Model Number, Model Year and Serial Number
1. Model Number, Model Year and Serial Number.
The vehicle serial number is located under the seat. (Ref
Fig. 3 on page 3)

CONTROLS, METERS AND SWITCHES

The controls, meters and switches consist of:
•
key switch
•
direction selector switch
•
power on/battery condition meter
•
headlight (accessory; standard on EE models; not
shown)
•
service/parking brake pedal
•
speed control pedal
•
horn
•
seat switch
•
hour meter (accessory; not shown. Located under
rear deck.)
1