Setting The Rf Out Channel; Presetting The Stations Automatically - Samsung SV-5000W Owner's Instructions Manual

Setting the RF OUT CHANNEL

GB
The initial setting of RF Channel is 60CH.
You can select the RF OUT CHANNEL for watching the VCR by TV
channel.
** INSTALLATION **
1
COUNTRY
AUTO SET UP
❿
MANUAL SET UP
2
❿ END:(MENU)
# ❷
3
4
** MANUAL SETUP **
TV STATION TABLE
5
MANUAL TUNING
RF OUT M/G/I/K/L :I
❿ RF OUT CH 21-69 :60
❿ END:(MENU)
# ❷
18
Press MENU on the remote control.
Result: The programming menu is displayed.
Press the or buttons to select installation.
Result: The installation menu is displayed.
Press the or buttons to select MANUAL SET UP.
Result: The MANUAL SET UP menu is displayed.
Press the button until the cursor is placed in front of RF OUT
CHANNEL.
Press the or buttons to change the RF OUT CHANNEL.
Result: The RF OUT CH is changed.
Your VCR RF out channel may need to be changed if the
pictures suffer from interference or your TV can not find
the pictures.
You can connect your VCR to the TV using the RCA or
Scart cable if the appropriate input is available on the TV
for better quality sound and picture.

Presetting the Stations Automatically

Your VCR contains a built-in tuner used to receive television
broadcasts. It can also receive cable television broadcasts.
You must preset the stations received through the tuner. This can
be done:
automatically ; or
manually (see page 20).
1
Press MENU on the remote control.
Result: The programming menu is displayed.
2
Press the corresponding or buttons, until the cursor is placed
in front of the INSTALLATION option.
3
Press the button to select this option.
Result: The INSTALLATION menu is displayed.
4
Press the corresponding or buttons, until the cursor is placed
in front of the AUTO SET UP option.
5 Press the button to select AUTO SET UP.
6 Press OK to start the auto scanning.
Result: The AUTO indication flashes on the VCR display.
The first frequency band is scanned and the first
station found is displayed and stored.
The VCR then searches for the second station and
so on.
When the automatic scanning procedure has
finished, the VCR switches automatically to
programme 1.
The number of stations automatically stored by the VCR
depends on the number of stations that it has found
(reception conditions, etc).
7
To exit the AUTO SET UP, press the MENU.
The time and date are set automatically from the
broadcast signal. If the signal is weak or ghosting
occurs, the time and date may not be set automatically.
In this case, they should be set manually (see page 15).
GB
OK
AUTO MENU
1
** INSTALLATION **
COUNTRY
❿ AUTO SET UP
MANUAL SET UP
❿
END:(MENU)
# ❷
EUROPE
U.K.
YOUR DATA WILL BE LOST
PRESS (OK) TO CONTINUE
(MENU) TO EXIT
AUTO SET UP
PLEASE WAIT
CH 2
END:(MENU)
19