Lucasey PCEC1417A Installation Instructions

PCEC1417A INSTALLATION INSTRUCTIONS
Philips monitor & base not
included with PCEC1417A

Component List

1 ... PCEC1417A Top Plate
1 ... PCEC1417A Bottom Plate
4 ... .400" Dia x .150" Tall Plastic Adhesive Buttons
Important! Please read all warnings and cautions before installing the mount.
Caution: Improper installation of this mount may void the warranty on your monitor.
Caution: Installation should be performed by qualified installers only, using construction methods prescribed
by authorized architects or engineers that comply to all applicable codes and standards.
The maximum weight of monitor to be installed on the PCEC1417A is 50lbs (22.7 kg)
Inspect all parts to make sure there is no shipping damage. Do not install if any parts are damaged.
Please call 1-800-LUCASEY or 1-510-534-1435 if you have any questions about this installation.
PCEC1417A (05/2010)
Page 1 of 3
PCEC1417A - Adhesive Furniture Mount
for Philips Models: 32HF5581, 37HFL5682L/F7
& 42HFL5682L/F7
1. Determine the appropriate location on the furniture for the
monitor. Mark a parallel line at the front edge of the Philips
monitor base. Mark a second parallel line 8-1/4" back from
the previous line.
2. Clean the furniture surface 2x with an alcohol wipe to
remove any residue on the furniture surface.
3. Peel the plastic liner from the Adhesive Tape on the Bottom
Plate. Avoid any accidental contact between the exposed
adhesive and any objects.
4. Carefully line up the front edge of the Bottom Plate with
the second line marked in step 1.
5. Press the PCEC1417A Bottom Plate down putting pressure
on each of the eight Adhesive Tape Locations.
©2010 Lucasey Manufacturing Corporation, Oakland, California
Steps 1-4
14"
Step 5
PCEC1417A Bottom Plate
(8 PL.) VHB Adhesive Tape, 1 sq. in.
www.lucasey.com