Lucasey THFSUL2014 Installation Instructions

THFSUL INSTALLATION INSTRUCTIONS Page 1 of 2
Flat Back Monitor Attachment
A
Monitor Not Included with THFSUL
Retaining Screw
Recessed Insert Monitor Attachment
THFSUL_Ins (2/10)
THFSUL2014, THFSUL2720 & THFSUL3520
Adapter Plate & Wall Mount for 24" to 60" Flat Screens
with Threaded Inserts up to 35" Apart and 20" Tall
Phillips Head Screw
Monitor Threaded Insert
DETAIL A
Hex Nut and Washer
B
DETAIL B
©2010 Lucasey Manufacturing Corporation, Oakland, California
Determine which type of monitor attaching hardware is required for the
monitor as specified by the monitor manufacturer. Various sizes of monitor
Flat Washer
attaching screws are provided for convenience (See the hardware list below)
If the monitor's inserts are flat along the back of the monitor, follow the
Flat Back Monitor Attachment instructions below. (DETAIL A) If the monitor
has recessed inserts, follow the Recessed Insert Monitor
Attachment instructions below. (DETAIL B)
Flat Back Monitor Attachment
1. Place the THFSUL Channels vertically on the threaded inserts with the
Retaining Screws at the bottom. Align four available holes in the channels
THFSUL Channel
with the monitor's inserts. The tops of the THFSUL Channels must be even.
2. Secure to the monitor with a washer and a Phillips screw in each insert.
Recessed Insert Monitor Attachment
1. Thread the setscrews at least 1/4" into the threaded inserts. Secure with
a nut and washer.
2. Use additional washers as spacers so that the top washer is level with
the surface of the back of the monitor. Check that the washers are all the
same height to keep the channels level on the mount.
3. Place the THFSUL Channels vertically over the setscrews with the
Retaining Screws at the bottom. The tops of the channels must be even.
4. Secure to the monitor with a washer and a nut for each setscrew.
Setscrew threaded
into monitor insert
#10-24 x 2-3/4 SHC Screws (included with THFSUL Channels)............ 4
#14 x 2-1/2" HWH Lag Screws ............................................................ 4
Washer level
1/4" x 1-1/4" Fender Washers ............................................................ 4
with monitor back
5/32" Hex Wrench ............................................................................... 1
4mm x 25mm Setscrews
Hex Nut & Washer
5mm x 30mm Setscrews
6mm x 30mm Setscrews
THFSUL Channel 8mm x 30mm Setscrews
4mm x 16mm Phillips Screws .. . 4
5mm x 16mm Phillips Screws ... 4
6mm x 16mm Phillips Screws ... 4
8mm x 16mm Phillips Screws ... 4
Hardware List
... 4 4mm Hex Nuts ... 8
... 4 5mm Hex Nuts ... 8
... 4 6mm Hex Nuts ... 8
... 4 8mm Hex Nuts ... 8
5mm Flat Washers ... 12
1/4" Flat Washers ... 12
8mm Flat Washers ... 12
www.lucasey.com