Lucasey TH100200W Installation Instructions

TH100200W INSTALLATION INSTRUCTIONS

Wall Plate Installation

TH100200W Wall Plate

Wall Arm Installation

TH100200W_Ins (5/13)
Page 1 of 3
TH100200W Wall Mount Installation
3Pl. #14 x 2-1/2" Lag Screws
(For metal stud walls, use WMATB3 toggle bolt kit
for concrete walls, use WMAAB3 anchorbolt kit,
sold separately)
Component List
1 ... TH100200W Wall Plate with Knuckle
1 ... TH100200W 6" Projection Wall Arm
5/16"-18 x 1-7/8"
1 ... TH100200W 3-1/2" Projection Wall Arm
Hex Flanged Head Screw
1 ... TH100200W 100/200mm Adapter
5/16" Belleville Washer
1 ... TH100200W 75/100mm VESA Plate
(Curved Side Facing Down)
1 ... 5/16"-18 x 1-7/8" Hex Flanged Head Screw
1 ... 5/16"-18 x 2" Hex Button Head Screw
1 ... 1/4"-20 x 2" Hex Button Head Screw
2 ... 5/16"-18 Nylock Nuts
1 ... 1/4"-20 Nylock Nut
4 ... 5/16" Flat Washers
3 ... 1/4" Belleville Washers
3Pl. 5/16" Belleville Washer
4 ... 5/16" Belleville Washers
(Curved Side Facing Up)
6 ... 6mm x 12mm Phillips Pan Head Screws
5/16" Flat Washer
4 ... 1/4" Flat Washers
4 ... 8mm x 20mm Phillips Pan Head Screws
5/16"-18 Nylock Nut
4 ... 8mm Flat Washers
©2013 Lucasey Manufacturing Corporation, Oakland, California
Wall Plate Installation
Measure from the floor and ceiling to the centerline for
where the screen needs to be mounted on the wall.
Make sure that appropriate clearance under the screen is
maintained by subtracting the distance from the bottom
of the screen to the center of the VESA mounting pattern.
Align the center of the TH100200W Wall Plate with the
centerline measurement for the screen. Use the
TH100200W Wall Plate as a template to mark the
locations to drill pilot holes. Make sure that the
TH100200W Wall Plate is level while marking the
pilot hole locations.
For wood studs, drill 1/8" holes 2-1/2" deep. (For metal
studs & concrete anchor bolts, consult the appropriate
fastener installation guide for the hole diameter needed)
Attach the TH100200W Wall Plate with the provided
#14 x 2-1/2" Lag Screws.
Adjust the TH100200W Wall Plate level and tighten
all 3 screws.
Wall Arm Installation
Attach the TH100200W Wall Arm to the TH100200W
Wall Plate with the 5/16"-18 x 1-7/8" Flanged Head
Screw, Washers & Nylock Nut as shown in the
illustration.
Tighten the pivot screw for the desired pivoting tension.
Note: The curved 5/16" Belleville Washers should be
installed with the curve facing towards the welded
knuckle (Top washer facing down and bottom washers
facing up) to facilitate smooth pivoting action.
www.lucasey.com