Boom; Grade And Side Slopes - JLG M45AJ Operators & Safety

2. If total load (personnel, tools and supplies) is 230
kg. or less, distribute load uniformly on platform
floor and proceed to work position.
Loading From Positions Above Ground Level
Before loading weight to platform above ground level:
1. Determine what the total weight will be after addi-
tional weight is loaded (personnel, tools and sup-
plies).
2. If total weight in platform will be 230 kg. or less, pro-
ceed with adding weight.
Platform Level Adjustment
1. Leveling UP . Depress footswitch to raise platform,
position PLATFORM/LEVEL control switch UP and
hold until platform is level.
2. Leveling DOWN. Depress footswitch to lower plat-
form, position PLATFORM/LEVEL control switch to
DOWN and hold until platform is level.
Platform Rotation
1. Depress footswitch to rotate platform to the left,
PLATFORM ROTATE control switch is positioned to
the LEFT and held until desired position is reached.
2. Depress footswitch to rotate platform to the right,
PLATFORM ROTATE control switch is positioned to
the RIGHT and held until desired position is
reached.
3120883
Figure 4-1. Grade and Side Slopes

4.7 BOOM

A RED TILT WARNING LIGHT IS LOCATED ON THE CONTROL
CONSOLE WHICH LIGHTS WHEN THE CHASSIS IS ON A 3
DEGREE OR GREATER SLOPE. DO NOT SWING OR RAISE BOOM
ABOVE HORIZONTAL WHEN LIGHT IS LIT.
DO NOT DEPEND ON TILT ALARM AS A LEVEL INDICATOR FOR
THE CHASSIS. TILT ALARM INDICATES CHASSIS IS ON A
SEVERE SLOPE (3 DEGREE OR GREATER). CHASSIS MUST BE
LEVEL BEFORE SWINGING, OR RAISING BOOM ABOVE HORI-
ZONTAL.
TO AVOID UPSET IF RED TILT WARNING LIGHT LIGHTS WHEN
BOOM IS RAISED ABOVE HORIZONTAL, LOWER PLATFORM TO
GROUND LEVEL. THEN REPOSITION MACHINE SO THAT CHAS-
SIS IS LEVEL BEFORE RAISING BOOM.
TRAVELING WITH BOOM BELOW HORIZONTAL IS PERMITTED
ON GRADES NOT EXCEEDING THOSE SPECIFIED ON THE
SERIAL NUMBER PLATE.
TO AVOID SERIOUS INJURY, DO NOT OPERATE MACHINERY IF
ANY CONTROL LEVER OR TOGGLE SWITCH CONTROLLING
PLATFORM MOVEMENT DOES NOT RETURN TO THE 'OFF' OR
NEUTRAL POSITION WHEN RELEASED.
TO AVOID A COLLISION AND INJURY IF PLATFORM DOES NOT
STOP WHEN A CONTROL SWITCH OR LEVER IS RELEASED,
REMOVE FOOT FROM FOOTSWITCH OR USE EMERGENCY STOP
SWITCH TO STOP THE MACHINE.
– JLG Lift –
SECTION 4 - MACHINE OPERATION
Updated 5-21-99
4-3