Table of Contents
Advertisement
8.0 Setup and Assembly
8.1 Unpacking
Open shipping container and check for shipping
damage. Report any damage immediately to your
distributor and shipping agent. Do not discard any
shipping material until the Turret Mill is assembled and
running properly.
Compare the contents of your container with the
following parts list to make sure all parts are intact.
Missing parts, if any, should be reported to your
distributor. Note: Check the mill first – some parts may
have been pre-installed on the mill.
Read the instruction manual thoroughly for assembly,
maintenance and safety instructions.
Read and understand the entire contents of this manual before attempting set-up or
operation! Failure to comply may cause serious injury.
If your mill is supplied with an optional Table Powerfeed and/or DRO, be sure to consult the separate instruction
materials that accompany them.
8.2 Contents of shipping container
Refer to Figure 3:
1
Turret Mill (not shown)
1
Flat Way Cover
1
Pleated Way Cover
1
Draw Bar
3
Table Adjustment Handles
1
Tool Box, containing:
1
1
1
1
1
1
1
1
1
1
1
1
* parts with an asterisk are also included in the tool
box service kit, p/n JTM4VS-TB.
Figure 3: Shipping contents
NOTE
9
Hex Key Set (1.5-10mm) *
17/19mm Box Wrench *
Cross Point Screw Driver #2 *
Flat Blade Screw Driver #2 *
Plastic Oil Bottle *
Elevating Crank Handle
Handwheel
Coarse Feed Handle
Can White Touch Up Paint
Lifting Ring
Operator's Manual (not shown)
Warranty Card (not shown)
Advertisement
Table of Contents
