Kohler KD83V16 Operation And Maintenance Manual page 79

Operation and Maintenance Manual
Component
Engine oil filters
standard - main
SL101
bearing with lube oil
"Category 3"
Centrifugal oil filter -
SL102
paper filter
Engine oil change
with lube oil "Cate-
gory 2" (2)
SL121
Engine oil change
with lube oil "Cate-
gory 3" (2)
SL105 Fuel main filter
Recommended:
SL106
Fuel prefilters
Recommended: Air
SL108
filters + Air ducting
SL109 Alternator belt
Alternator belt
SL110
tensioner
KD83V16 33521030601_0_1 EN_US
2018-07
Service
Schedule
Type
500 2Y X
500 2Y X
500 2Y X
1000 2Y X
1000 2Y X
1000 2Y X
3000 2Y X
1000 2Y X
1000 18Y
© 2018 by Kohler Co. All rights reserved.
Task description
Replace filters. Clean the seal area before removal
the old filter to prevent oil contamination.
information see: 5.7.6 Changing Diesel engine oil —
SL101/SL121, page 107)
Replace the paper (sleeve) for sludge at each oil
change. Measure and record thickness of the sludge
accumulated on paper if above limits. Reduce lube oil
interval if the sludge accumulated is above limits.
(For more information see: 5.7.5 Replacing centrifuge
paper filter — SL102, page 103)
Oil Change Maximum Interval. Note : Replace Diesel
engine oil at least every 2 years. Final lube oil interval
depends on exchange interval factor according to
lube oil category and fuel sulfur rate. 0<fuel sulfur
rate<0.5%: the factor is 1 (no change on the lube oil
change interval). 0.5<fuel Sulfur rate<1%: the factor
is 1/2 (reduce by 2 times the lube oil change interval
and use only lube oil category 2 or 3). 1<fuel sulfur
rate <1.5%: requires additional approval. No oil Cate-
gory 1 in case of K175.
5.7.6 Changing Diesel engine oil — SL101/SL121,
page 107) .
Replace main fuel filter cartridge.
tion see: 5.9.2 Replacing main filter - SL105,
page 117) .
Replace primary fuel filter cartridge.
See the operator and maintenance manual of your
application.
Replace the air filter and clean air ducting between
air filter and compressor.
See the operator and maintenance manual of your
application.
Inspect conditions of drive belt and fit new one if
necessary. (For more information see: 5.6.4 Checking
X drive belt — SL109, page 96)
(For more information see: 5.6.5 Replacing V-ribbed
belt — SL 109, page 97)
Visual inspection of the tensioner. Replacement if
X necessary. (For more information see: 5.6.6
Replacing tensioning device — SL110, page 98)
Maintenance
Service level definition
(For more
.
.
(For more information see:
(For more informa-
. Check belt tension.
.
.
79