Replacing Centrifuge Paper Filter - Sl102 - Kohler KD83V16 Operation And Maintenance Manual

Operation and Maintenance Manual
Fig. 60: Spin-on oil filters
1 Spin-on oil filter
2 Filter head
Spin-on oil filter removal
u Clean sealing area.
u Open spin-on oil filter 1 with filter wrench.
u Remove filter.
u Repeat procedure for all filters.
Spin-on oil filter installation
u Clean sealing area.
u Lubricate filter seal 3 with engine oil.
u Screw spin-on oil filter 1 in filter head 2 until it contacts base.
u Tighten filter by hand by 1/2 turn.
u Operate prelubricating pump to vent the filters.
u In the absence of prelubricating pump, disconnect TDC sensor (flywheel) and start engine until
oil pressure shows up.
u Reconnect TDC sensor.
u Check for leaks and damages.
u Retighten if necessary.
5.7.5 Replacing centrifuge paper filter — SL102
WARNING
Hazards by hot engine oil!
Serious injuries or death by burns or skin penetrating oil.
u Avoid skin contact with the engine oil.
u Wear proper personal protective equipment.
KD83V16 33521030601_0_1 EN_US
2018-07
3
© 2018 by Kohler Co. All rights reserved.
Seal
Maintenance
Lubricating system
103