Table of Contents
Advertisement
www.freeservicemanuals.info
Relay gear
B
B
2.2.4 Pinch Roller Arm Assembly
1. How to remove
(1) Remove the spring from the hook of the press lever as-
sembly.
(2) Remove the slit washer and remove the pinch roller seat
2. (See Fig.2-2-4a.)
(3) Remove the pinch roller arm assembly by pulling it up.
Pinch roller arm assembly
2.2.5 Guide Arm Assembly and Press Lever Assembly
1. How to remove
(1) Remove the spring and expand the lug of the lid guide in
the arrow-indicated direction. Then remove the guide arm
assembly by pulling it up.
(2) Remove the press lever assembly by pulling it up. (See
Fig.2-2-5a.)
Tension
spring
Notches
Guide hole
Notch
A
A
Drive gear
Limit gear
Fig. 2-2-3i
Slit washer
Pinch roller seat2
Pinch roller arm
assembly
Press lever assembly
Fig. 2-2-4a
Press lever
assembly
Guide arm
assembly
Lid guide
Lug
Fig. 2-2-5a
Digitized in Heiloo Netherlands
2.2.6 Audio Control Head
1. How to remove
(1) Remove the two screws (A) and remove the audio con-
trol head together with the head base.
(2) When replacing only the audio control head, remove the
three screws (B) while controlling the compression spring.
Audio control head
Audio control head
Audio control head
board assembly
Spring
2. How to install
(1) To make the post-installation adjustment easier, set the
temporary level as indicated in Fig.2-2-6c. Also make sure
that the screw center (centre) is brought into alignment
with the center (centre) position of the slot.
A/C head
12.4 mm
2.2.7 Loading Motor
1. How to remove
(1) Remove the belt wound around the worm gear.
(2) Open the two lugs of the motor guide and remove the
loading motor, loading motor board assembly and motor
guide altogether by pulling them up.
(3) When replacing the loading motor board assembly, take
care with the orientation of the loading motor. (Install so
that the loading motor label faces upward.)
(4) When the motor pulley has been replaced, choose the
fitting dimension as indicated in Fig.2-2-7a.
Head base
Screws(A)
Fig. 2-2-6a
Screws(B)
Compression
springs
Head base
Fig. 2-2-6b
Head base
Audio control head
Fig. 2-2-6c
1/21/2018
Head base
Screw
2-8
Advertisement
Table of Contents
